Wall panel machine for 3 sizes

Catalog Roll forming machines Wall panel machines Wall panel machine for 3 sizes

Company Ruscana Engineering represents high-tech, machine for producing wall panels of several types with different shelf widths with minimal time loss for readjustment (5 minutes).
The advantages of wall panels:

resistance to sharp temperature changes;
no flammability;
corrosion resistance, increased resistance to atmospheric precipitation, ultraviolet and aggressive environments;
low coefficient of thermal expansion;
high strength characteristics, resistance to mechanical influences;
manufacturability, convenience and reliability of installation (fast installation at any time of the year);
hidden fastenings;
the cladding panel allows you to reduce the cost for heating the house (however the cladding is breathing, since it is not closed tightly);
attractive appearance;
environmental safety.

As a result, you get not expensive and aesthetically attractive cladding that can change the appearance of the building.
Company «Rusсana Engineering» offer for your consideration wall panel machine (for 3 sizes).
Wall panel machine is an integral part of the roll forming line.
This panel roll forming line is reliable, convenient in operation and produce high quality end product

DISTINCTIVE FEATURES

High production speed 20 m/min.

Well equipped line

Cantilevered decoiler with a lifting capacity of 3000 kg.

The cantilever type provides fast coil replacement.

Roll forming section is designed in such way that it allows to produce a wall panel profile of 3 sizes.

Switching between profile sizes from the control panel with a button.

6 types of decorative embossing.

6 types of decorative embossing of the profile is available: relief module «Micro wave», «Band», «Trapezium», «Groove» and perforation module "Soffit" of two types.

Variety of wall panel types.

For today, there are lots of metal wall panel types.

Company «Ruscana Engineering» is ready to offer you a standard metal panel types and develop and manufacture machine to produce original look wall panel in accordance with your sketch.

GENERAL INFORMATION

Raw material requirements
Material	Light-gauge galvanized steel with polymer coating: polyester, plastisol Zinc coating to range 100…275 g/m² Yield strength 320…350 N/mm²
Coil thickness	0,45 mm….0,6 mm
Coil width	312,5 ± 1 mm 250 ± 1 mm 208 ± 1 mm
General characteristics
Line operating mode	manual/semiautomatic
Installed power capacity, no more than	8 kW
Roll forming speed, no more than	20 m/min
Supply voltage at frequency of 50 Hz	380 V
Supply voltage at frequency of 60 Hz	230 V 3 phase
Dimensions (LxWxH), no more than	13200х2250х1450mm (receiving table is included)
Weight, no more than	4500 kg
Required operation personnel	1-2 persons
Line configuration
1. Decoiler
2. Roll forming section
3. Guillotine integrated into the roll forming section
4. Receiving table (roller table)
5. Automatic Control System (ACS)

PROFILE DRAWING

metal log siding wall panel roll forming line

GET A QUOTE