Request a Quote
+1-647-342-2118 America
+7-495-726-00-15 Europe
sales@ruscana-engineering.com
Elbow making machine and crimping machine

Company «Ruscana Engineering» develops and manufacture elbow making machine and crimping machine.
Elbow making machine

Download PDF file

Pipe elbow is one of the main elements of the rain water system.
This element is often used for connecting hopper with a vertical down pipe at the desired angle of inclination.
The most common models of pipe elbows with bends of 45, 60 and 90 degrees.
Pipe elbow can be used to solve various issues. Basically, this element is used in the following cases:

  • if necessary, to ensure a reliable discharge of water not at the wall, but a little farther, pipe elbow is used in this case;
  • often some structures interfere with the installation of the water system elements and to circumvent such structures it is required to put the pipe at a certain angle (this can be done with the help of the down pipe elbow);
  • it is not always possible to connect the hopper with the down pipe directly, therefore, in this case, the elbow is used as the connecting piece.

Crimping machine

Download PDF file


This machine is designed for crimping the end part of the downpipe and pipe elbow.
These crimps are necessary for joining the elements of the rain water system with each other.
This machine is usually used as a part of the down pipe roll forming line.

GENERAL INFORMATIOM
Elbow making machine
Raw material requirements
Material

Light-gauge galvanized steel with polymer coating: polyester, plastisol
Zinc coating to range 100…275 g/m²
Yield strength 280…320 N/mm²

Coil thickness 0,45 mm up to 0,5 mm
Diameter of the pipe 92 mm ±2 mm
Angle of bending of the elbow, α° 120 ± 5°
General characteristics
Line operating mode manual/semi-automatic
Installed power capacity, no more than 3 kW
Production speed 3 products/min
Supply voltage at frequency of 50 Hz 380 V
*Electrical supply network for countries of North America: Supply voltage at frequency of 60 Hz 230 V  3 phase
Dimensions (LxWxH), no more than 950х600х1550 mm (including receiving table)
Weight, no more than 350 kg
Required operation personnel 1 persons
Crimping machine
Raw material requirements
Material

Light-gauge galvanized steel with polymer coating: polyester, plastisol
Zinc coating to range 100…275 g/m²
Yield strength 280…320 N/mm²

Coil thickness 0,45 mm up to 0,5 mm
Diameter of the pipe 92 mm ±2 mm
General characteristics
Line operating mode manual /semi-automatic
Installed power capacity, no more than 2,2  kW
Production speed 10 products/min
Supply voltage at frequency of 50 Hz 380 V
*Electrical supply network for countries of North America: Supply voltage at frequency of 60 Hz 230 V  3 phase
Dimensions (LxWxH), no more than 1100х750х1650 mm
Weight, no more than 850  kg
Required operation personnel 1 persons
GET A QUOTE